Heat & Glo • Kenwood Corner Surround • 2118-934 • 4/07
2
MANTEL TOP
LEFT LEG
RIGHT LEG
UPPER TRIM
RIGHT TRIM
LEFT TRIM
FACE BOARD
BASE (OPTIONAL)
TOP FINISH SUPPORT
SIDE FINISH
SUPPORT
Parts List and Diagram
MANTEL PARTS:
QTY DESCRIPTION
1 Mantel
Top
1 Right
Leg
1 Left
Leg
1 Face
Board
1 Upper
Trim
1 Left
Trim
1 Right
Trim
1 Base
(Optional)
2
Side Ledger Board (not shown)
2
Top Ledger Board (not shown)
1
Top Finish Support
2 Side
Finish
Support
ASSEMBLE MANTEL
1. Remove all components from packaging. Con
fi
rm
that all components are included. See Figure 2.
Note: Side and Top
fi
nish material supports may come
pre-assembled to left and right legs and face board. If
they are shipped separately they should be attached
prior to step 2.
2. Position left and right mantel legs laying
fl
at on a
clean
fl
oor.
3. Attach face board to the legs. See Figure 3.
4. Make sure all seams and edges are tight and
square.
5. Carefully lift assembly into upright position.
6. Have someone hold the front and legs from the front,
and set the mantel top into location. Attach the mantel
top. See
fi
gure 4.
Figure 2. Components Overview
Figure 3. Attaching Face Board
Figure 4. Attaching Mantel
Note: Using the optional base will raise the
fi
replace by
9-1/4 inches above
fi
nished
fl
oor level. All dimensional
requirements of the
fi
replace installation manual should be
adjusted accordingly. See
fi
replace installation manual for
more details.
INSTALLATION
1. Position base on the
fl
oor in the desired
fi
replace
location (optional).
2. Set Fireplace into position.
3. Carefully position mantel in desired location.
