5
NOTE: DIMENSIONS SHOWN WITH THE SIDES, BACK
AND/OR CORNERS OF THE UNIT TOUCHING THE WALL.
Figure 2.
Fireplace Dimensions, Locations, and
Space Requirements
Minimum Clearances
from the Fireplace to Combustible Materials
Inches
mm
Glass Front ...................................... 36 ........ 914
Floor .................................................. 0 ........... 0
Rear ................................................. 1/2 ........ 13
Sides ............................................... 1/2 ........ 13
Top ................................................. 1 1/2 ....... 38
Ceiling* ............................................. 31 ........ 787
For minimum clearances, see the direct vent termina-
tion clearance in Figures 19 and 24.
Minimum Clearances
from the Vent Pipe to Combustible Materials
Inches
mm
Vertical Sections
. .............. 1................. 25
Horizontal Sections
Top ...................................... 3................. 75
Bottom ................................ 1................. 25
Sides .................................. 1................. 25
At Wall Firestops
Top ................................... 2 1/2 ............. 63.7
Bottom .............................. 1/2 ............... 13
Sides .................................. 1................. 25
*The clearance to the ceiling is measured from the top
of the unit, excluding the standoffs (see Figure 27).
A
B
C
D
E
3 7
16 1/4
29 3/8
41 1/2
58 3/4
(940mm) (418mm) (746mm)
(1054mm) (1492mm)
1.0 INSTALLATION INSTRUCTIONS
In planning the installation for the heater it is neces-
sary to determine where the unit is to be installed, the
type of flue system to be used (straight out, corner, or
elevated), and whether optional accessories (wall
switch or remote control) are desired. Gas supply pip-
ing should also be planned. Refer to the appliance data
plate on the base pan of the heater for all gas pres-
sures and input rate information.
The heater can be mounted on any of the following
surface:
1. A flat surface (minimum 6mm base).
2. Four (4) corner supports.
(Example: Four (4) concrete masonry blocks). These
supports must be positioned so they contact all four
(4) perimeter edges on the bottom of the unit.
Heater framing can be built before or after the heater is
set in place. Framing should be positioned to accom-
modate wall covering and heater facing material. The
heater framing should be constructed of 2" X 4" (51 x
102mm) lumber or heavier. The framing headers may
rest on the heater standoffs. Refer to Figure 2 and Fig-
ure 3 for heater and framing reference dimensions.
1/2” MIN. (13mm)
C
3” MIN. (76mm)
A
B
D
E