29
1. "STOP!" Read the safety information on previous
page.
2. To access controls, open the bottom grille.
3. Turn the valve control knob to the "OFF" position.
To do this, you must turn the knob clockwise
to the "Pilot" position, and then press
in and continue turning clockwise
to
the "OFF" position.
GAS CONTROL VALVE
NOTE:
Knob cannot be turned from "PILOT" to
"OFF" unless knob is pushed in slightly. Do not
force.
4. WAIT FIVE (5) MINUTES TO CLEAR OUT
ANY GAS. Then smell for gas, including near
the floor. If you then smell gas, STOP! Follow
"B" in the safety information on the previous
page. If you don't smell gas, go to the next step.
5. The pilot should not require accessing for lighting
purposes. The pilot is located inside the
combustion chamber.
2.3
LIGHTING INSTRUCTIONS
THERMOCOUPLE
THERMOPILE
6. To put the control in the pilot position, turn the
control knob counter-clockwise
to the
"Pilot" position.
7. To light the pilot depress the control knob and then
depress the red or black piezo button until it
makes a clicking sound. It may be necessary to
repeat this step. If the pilot does not light after 10
seconds, go back to step 3. The control knob
should be held down for a MINUTE after pilot
ignition.
• If the control knob does not pop out when
released,
STOP
-shut off the gas supply to
the fireplace control valve, and
IMMEDIATELY
call your service technician or gas supplier.
• If the pilot will not stay lit after two tries, turn
the control knob to the "OFF" position and
call your service technician or gas supplier.
8. After the pilot has been lit, the burner can be turned
on by turning the knob counter-clockwise
to the "ON" position. Flip the ON/OFF
switch to the "ON" position.
9. Close the bottom grille.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS APPLIANCE
1. Open the bottom grille.
2. Turn ON/OFF switch to "OFF".
3. Turn the valve control knob clockwise
to
the "Pilot" position, then depress knob and
continue turning to "OFF" position.
4. Close the bottom grille.
PILOT BURNER
u