37
Heat & Glo • SUPREME-I25-IFT, SUPREME-I30-IFT, SUPREME-I35-IFT Installation Manual • 2532-980 Rev. E • 5/19
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
Note:
Remove the zip ties from the appliance that hold
the electrical cord, gas flexline and multi-purpose tool in
place for shipping.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap
-
proved accessories.
WARNING! Risk of Fire and Electric Shock!
Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
F. Ember Placement
WARNING! Risk of Explosion!
Follow ember placement
instructions in manual. Replace ember material annually.
Improperly placed embers interfere with proper burner op-
eration.
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over burner ports
that are indicated in Figure 9.3 or in pilot area as indicated
in Figure 9.3.
• Embers may be placed on the ports in areas indicated in
Figure 9.3. These embers must be placed loosely over
the port holes, not pressed down on or into the holes.
Create a single layer, no more than 1/4 inch thick.
•
Failure to follow this procedure will likely cause lighting
and sooting problems.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
E. Mystic Embers Placement
WARNING! Risk of Explosion!
Follow mystic ember
placement instructions.
DO NOT
place mystic embers on
burner. Improperly placed mystic embers interferes with
proper burner operation.
Mystic embers is shipped with this gas appliance. To place
the embers:
• Embers CANNOT be placed on the burner.
• Place embers in front of and to the sides of the burner.
• Use mystic embers to mask transition between base
refractory and base pan. See Figure 9.3.
Figure 9.3 Placement of Embers
NO EMBERS
SUPREME-I25-IFT
SUPREME-I30-IFT
SUPREME-I35-IFT
MYSTIC
EMBERS
