Heat Controller EKTC07-1G, Owner'S Manual, Page: 9 / 18

Heat Controller, Inc.
OwnEr’s Manual
Packaged Terminal A/C
8
InsTall unIT InTO wall slEEVE
CAUTION
unIT DaMaGE HaZarD
Failure to follow this caution may result in equipment
damage or improper operation.
Failure to remove shipping tape and screw will prevent
fresh air vent door from opening and may result in
damage to vent door cable
!
1. Carefully remove shipping tape from the front panel and vent door. See Fig. 5 .
2. Remove shipping screw from the vent door, if present. See Fig. 6 .
3. Remove front panel. See Fig. 7 .
4. Lift unit level and slide unit into wall sleeve until foam seal rests firmly against front of wall sleeve.
5. Secure with four screws (supplied) through the unit flange holes.
See Fig. 8.
6. Reinstall front panel. See Fig. 9 .
Fig. 5—Shipping Tape Location
Fig. 7—Removing Front Panel
Fig. 8—Securing Unit
Fig. 9—Replacing Front Panel
Pull out at the bottom to release it from the tabs (1).
Then lift up (2).
Place tabs over top rail (1). Push Inward at bottom
until panel snaps into place (2).
6
Shipping
tape
Remove shipping
screw if present