Heat Controller Comfort-Aire PS-101A, Installation, Operation & Maintenance Manual, Page: 10 / 16

10
Installation, Operation & Maintenance
PS-81, 101, 121A
Heat Controller, Inc.
B
A
INSTALLATION INSTRUCTIONS
Horizontal
window
Window Slider Kit
Minimum: A
Maximum: B
Window Slider Kit
Minimum: A
Maximum: B
Horizontal
window
Fig.6
Fig.7
Location
The air conditioner should be placed on a firm
foundation to minimize noise and virbration. For
safe and secure positioning, place the unit on a
smooth, level floor strong enough to support the unit.
The unit has casters to aid placement, but it should
only be rolled on smooth, flat surfaces. Use caution
when rolling on carpet surfaces. Do not attempt to
roll the unit over objects.
The unit must be placed within reach of a properly
rated grounded socket.
Never place any obstacles around the air inlet or
outlet of the unit.
Allow 1ft.-3ft.(30cm to 100cm) of space from the
wall with for efficient air-conditioning. (Fig.5)
Your window slider kit has been designed to fit most
standard "Vertical" and "horizontal"window
applications. However, it may be necessary for you to
improvise/modify some aspects of the installation
procedures for certain types of windows. Please refer
to Fig. 6 & Fig.7 for minimum and maximum window
openings. Window slider kit can be fixed with a bolt
(see Fig.7a).
Window slider kit Installation
Note: If the window opening is less than the mentioned
minimum length of the window slider kit, cut the one
with a hole in it to fit the window opening.
Do never cut out the hole in window slider kit.
INSTALLATION INSTRUCTIONS
bolt
Window slider kit
Fig.7a
Fig.5
in. in.
cm cm
26-9/16 67.5 48-1/2 123
A
Minimum
B
Maximum
A:1ft.-3ft.(30cm-100cm) B: 1ft.( 30cm)
INSTALLATION INSTRUCTIONS
Installation in a double-hung sash
window
1. Cut the foam seal (adhesive type) to the proper length and
attach it to the window stool. Fig.8
2. Attach the window slider kit to the window stool. Adjust the
length of the window slider kit according to the width of
window, shorten the adjustable window kit if the width of
window is less than 26.5” (67.5 cm). Open the window sash
and place the window slider kit on the window stool. Fig.9
3. Cut the foam seal (adhesive type) to the proper length
and attach it on the top of the window. Shown as in Fig.10
4. Close the window sash securely against the window.
5. Cut the foam seal to an appropriate length and seal the
open gap between the top window sash and outer window
sash. Shown as in Fig.11.
Foam seal A
(adhesive type)
Foam seal
Fig.8
Fig.9
Fig.10
Fig.11
Window kit
Window stool
Window kit
Window stool
C
C
Min-max.
26.5”~ 48.5” (67.5-123 cm)