27
1. Place the ember
material directly
onto the top of the
burner.
Positioning the Logs
If the gas logs have been factory installed they should
not need to be positioned.
If the logs have been packaged separately, refer to the
installation instructions that accompany the logs.
Save the log instructions with this manual.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.
Placing the Ember Material
Two separate bags of ember material are shipped with
this gas fireplace:
• The bag labeled Golden Ember (GE-93) is flame
colorant material.
• The bag labeled Glowing Ember (050-721) is
standard glowing ember material.
To place the ember material:
• Remove the glass door from the unit.
• Cover the top of the burner with a single layer of em-
ber material. Then sprinkle GE-93 on top of the burner.
• Save the remaining ember materials for use during
fireplace servicing.
• Replace the glass door and a front trim door on the
unit (see Replacement Parts Section of the manual.)
Step 9
Installing Logs
and Ember
Material
WARNING: WHEN FINISHING THE STOVE,
NEVER OBSTRUCT OR MODIFY THE AIR
INLET/OUTLET GRILLES IN ANY MANNER.
!
Step 8
Finishing
Figure 26. Combustible Mantel Minimum
Do not install combustible
mantel or other combustible
projection closer than 55
inches minimum above the
top of the unit.
HEARTH EXTENSION
While a hearth extension
may be desireable for
aesthetic reasons, it is not
required for gas fireplace
heaters per ANSI or CSA
testing standards.
Figure 27. Placement of the Ember Material
