31
Heat & Glo • Tiara Petite B • 7026-101 Rev. N • 10/11
8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Leg Leveling System
Figure 8.1
Thread Allen bolts through nuts until fl ush. The
Allen bolts and nuts are included in the component pack inside
the appliance fi rebox.
Figure 8.2
Slide assembled nuts and bolts into the slots on
the legs with the nuts on the bottom.
Figure 8.3
Use a 5/32 in. 4mm) Allen wrench to adjust legs
up and down to desired level.
C. Flue Restrictor Installation
Figure 8.4
Installation of the fl ue restrictor requires the removal
of the baffl e located inside the fi rebox. Remove the baffl e
by fi rst removing the two screws holding the baffl e in place
(one on each side).
Lift the baffl e out of the bracket along the back of the fi rebox,
angle the baffl e slightly and remove it from the fi rebox.
Figure 8.5
With the baffl e removed, remove the two screws
located in the back of the fi rebox. Reuse the screws to install
the fl ue restrictor.
Reinstall the baffl e using the two screws
previously removed.
The fl ue restrictor should be used in all situations that fall
within the shaded area on the vent graph.
When your installation falls within a shaded area on the vent
graph (page 11), a fl ue restrictor must be installed for proper
operation.
