4
Heat & Glo • Primo Clean Face Finish Instructions • 2310-925 Rev. D • 8/15
Figure 3.
1/2 INCH SHEETROCK WALL
The PRIMO appliance can be
fi
nished with 1/2 inch
sheetrock. Non-combustible
fi
nishing is not required.
8 INCHES ALL SIDES
Figure 5. Feather Mud Evenly
Preparation
1. Install 1/2 inch sheetrock on wall. Figure 3 shows
the PRIMO installed. Sheetrock (1/2 inch) has been
installed up to the top, bottom and sides of appliance
opening as shown in Figure 2 and 3. See the appliance
installation manual for more details regarding facing
material.
KIT COMPONENTS
(1) Left Glass Panel
(1) Right Glass Panel
(1) Back Glass Panel (Single-sided models only)
(3) Glass Retaining Brackets
(2) Glass Clips
(1) Barrier Glass* (Qty 2 on See-Through models)
*See appliance installation manual for barrier glass instal-
lation instructions.
4. Glass Panel Instructions
Single-Sided Models:
Set back glass panel, in location A in Figure 6 into
fi
rebox.
Back panel will sit on the heads of the screws holding
the media tray in place. Set back glass panel against
the back wall of the
fi
rebox with the smooth side of the
glass facing outward. Place retaining bracket over panel
so holes in the bracket are against the
fi
rebox back. Use
two self-drilling screws to secure to the
fi
rebox back. En-
sure glass panel is stationary. See Figure 7.
Position the glass clip as shown in Figure 8.
NOTICE:
Fasteners are not used with glass clip.
Set left side glass panel, in location B in Figure 6, into
fi
re-
box with the smooth side facing outward. Place retaining
bracket over panel so holes in the bracket are against
the
fi
rebox side. Use two self-drilling screws to secure
to the
fi
rebox side. See Figure 7. Ensure glass panel is
stationary.
Repeat for right side panel.
See-Through Models:
Position the glass clip as shown in Figure 8.
NOTICE:
Fasteners are not used with glass clip.
Set left side glass panel, labeled B in Figure 6, into
fi
re-
box with the smooth side facing outward. Place retain-
ing bracket over glass panel so holes in the bracket are
against the
fi
rebox side. Use two self-drilling screws to
secure the bracket to the
fi
rebox side. See Figure 7. Re-
peat for right side panel.
2. Install sheetrock trim strips as shown in Figure 4 on all
sides of appliance. Sheetrock trim strips are included
with the appliance. Cut the strips to the required
length and install them using staples. See Figure 4 for
placement of trim strips.
Figure 4. Install Sheetrock Trim Strips
SHEETROCK TRIM STRIPS
SHEETROCK TRIM STRIPS
(INSTALLED ON ALL 4 SIDES)
(INSTALLED ON ALL 4 SIDES)
SHEETROCK
SHEETROCK
TRIM STRIPS
TRIM STRIPS
(INSTALLED
(INSTALLED
ON ALL 4
ON ALL 4
SIDES)
SIDES)
CORRECT
Installed OVER painted stop
INCORRECT
Installed UNDER painted stop
