1
Heat & Glo • Primo Clean Face Finish Instructions • 2310-925 Rev. D • 8/15
PRIMO CLEAN FACE FINISH
PRIMO48-CF, PRIMO48ST-CF, PRIMO60-CF, PRIMO60ST-CF, PRIMO72-CF, PRIMO72ST-CF
MODELS: PRIMO48, PRIMO48ST, PRIMO60, PRIMO60ST, PRIMO72, PRIMO72ST
Installation Instructions
Leave this manual with party responsible for use
and operation.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
CAUTION! Do not install damaged components.
WARNING! Risk of Fire!
Combustible materials
MUST
NOT
overlap or be placed behind a decorative front.
WARNING! Risk of Fire! DO NOT
apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as speci
fi
ed in
appliance installation manual.
Note
: To avoid potential damage to hearth pad or flooring,
protect area in front of fireplace by laying cardboard or
blanket down.
DANGER
HOT GLASS
WILL
CAUSE BURNS.
DO NOT TOUCH
GLASS
UNTIL COOLED.
NEVER
ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
Clean Face Finish (Black Glass Interior)
PRIMO48-CF PRIMO48ST-CF
PRIMO60-CF PRIMO60ST-CF
PRIMO72-CF PRIMO72ST-CF
The PRIMO appliance can be
fi
nished with 1/2 inch
sheetrock. Non-combustible
fi
nishing is not required.
During operation, the sheetrock will remain cool to the
touch.
Facing and Finishing - General Information
WARNING! Risk of Fire!
Comply with all minimum clear-
ances to combustibles as speci
fi
ed. Framing closer than the
minimums listed must be constructed entirely of noncom-
bustible materials (i.e., steel studs, concrete board, etc.).
Splatter Guard
The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before
fi
nishing work on the whole hearth is
complete. A splatter guard is factory-installed on PRI-
MO models. Splatter guards must be removed before
appliance is
fi
red.
WARNING! Risk of Fire!
Remove the splatter guard be-
fore lighting the appliance. Shut off gas to the appliance
when the splatter guard is in place to prevent accidental
operation.
Finishing Instructions
It is important to follow the framing and
fi
nishing instruc-
tions to ensure proper placement of
fi
replace into the sur-
rounding framing/
fi
nishing materials.
Wall sheathing materials 1/2 in. thick are speci
fi
ed
in this installation manual to properly align with the op-
tional
fi
nishing methods offered with this appliance. The
PRIMO may be
fi
nished to the appliance opening with 1/2
inch thick sheetrock.
•
Ensure that the one inch back clearance and one inch
side clearances are maintained
.
WARNING! Risk of Fire!
Maintain speci
fi
ed air space
clearances to combustibles. Inadequate air space could
cause overheating and
fi
re.
This appliance comes standard with patented
SafeSurface
TM
Glass which keeps the surface temperature
of the barrier glass at a safe level and will still be hot to
the touch when operated for long periods of time.
If the barrier glass is removed, the inner glass temperature
will be very hot and cause burns.
