2
Heat & Glo • GLASS-5/7/9, GLASS-3X/5X/7X/9X Installation Instructions • 2372-951 Rev. F • 11/18
5. Remove the new rear lower glass bracket from the
packaging and bend the hand bend features “up” to
about 45 degrees. See Figure 4. Install the new rear
lower glass bracket with screws removed in Step 3.
Note:
The new lower glass bracket spans the entire
width of the back wall of the firebox and rests above
the side lower glass brackets. See Figure 4, Detail A.
Figure 4. Bend Tabs on Lower Side and Rear Glass Brackets
6. Gently pull the pilot tube and pilot wires down,
grasping them from beneath the firebox to remove
slack in pilot wires. Reattach pilot assembly to pilot
bracket.
7. Locate, remove and discard the two screws
located below the rear exhaust hole. See Figure
5. Install the sleeve onto each 1-1/4 inch (32
mm)screw and install in holes. See Figure 6.
350X-AU, 550X-AU:
These screws attach the upper
heat shield to the back of the firebox. Replace
these screws with the 1-1/4 inch (32 mm) screws
and sleeves without removing the heat shield.
Figure 5. Remove Screws
Figure 6. Install Sleeves
REMOVE SCREWS
REAR GLASS BRACKET
DETAIL A
BEND TABS UP
4. Remove lower glass brackets from packaging and
bend “up” hand bend features. See Figure 3. Install
left and right lower glass brackets by installing them
between the outer edges of the left and right hearth
pieces with the notch facing the front of the appliance.
These pieces will fit tightly between the hearth sides
and the firebox. See Figure 3.
Figure 3. Install Lower Glass Bracket (Left Side Shown)
NOTCH FACES FRONT OF APPLIANCE
