Heat & Glo • EVEREST-B • 2367-900 Rev. G • 6/18
45
LOG NUMBER 3 (SRV750-702A):
Place the right burner log #3 on the right side of the grate. With
your left
hand, slide the air shutter on the end of the burner neck on to the orifice as shown in Figure 1. If the log
is difficult to place, check the grate to be sure that it is centered from left to right. When installed correctly, the
burner tube is pushed to within 1/8” of the back of the orifice (see Figure 1). Position the base of the log next to
the outer right grate tine with the burner neck resting on the grate. Place the top of the log into the groove on the
back log.
LOG NUMBER 4 (SRV750-705):
Place the top of the right inside log #4 in the groove on the back log.
Place the base of the log on the inside of the outer right grate tine with the tine fitting in the groove on the log.
NOTE: Burner Neck and Orifice Fitting
Make sure all three burner necks are pushed to within
1/8” of the back of the orifice (see Figure 1).
Figure 1
BURNER NECK
ORIFICE
