Heat & Glo • Escape-I35FB, Escape-I30FB • 2201-900 Rev. K • 5/11
32
H. Install the Log Assembly
Log Set Assembly: LOGS-I30FB
Models: Escape-I30FB, Escape-I30FB-LP
Figure 1. Logs Installed
Figure 2. Reference Points
Figure 3. Fill Light Holes with Glass Rock
Figure 4. Place Log #1
Glass Rock (2201-853)
: Fill each light hole evenly with the glass rock. Use all of the provided glass rock.
Log #1 (SRV2201-701)
: See Figure 2 and Figure 5 for additional references. Position Log #1 as shown above. Rest the
rear burner ledge steps, located on the bottom of the log, on the burner ledge. Slide the log forward, until the burner ledge
steps contact the vertical wall of the burner top. Ensure the right side of the log is touching the fi rebox. See Figure 4.
GRATE BAR
GRATE TINES
PILOT BRACKET
BURNER LEDGE
CAUTION: Logs are fragile, handle with care.
BURNER LEDGE
LIGHT HOLES
Figure 5. Bottom View of Log #1
VERTICAL PORTION OF BURNER TUB
RESTS AGAINST THIS LINE
RIGHT
END
THIS AREA RESTS ON THE BURNER TOP
LEFT
END
BURNER LEDGE STEPS
GLASS ROCK/MEDIA
1
FLAT SPOT
FOR LOG #6
LOG TOUCHES SIDE
OF FIREBOX
SRV2201-701
SRV2201-702
SRV2201-703
SRV2201-704
SRV2201-705
SRV2201-706
LOG PINS
1
6
5
4
3
2