Heat-N-Glo Lifestyle Collection • Dakota 42/Dakota 42H • 4036-905 Rev I • 10/05
13
Battery
polarity must be correct or module damage will
occur.
CAUTION
Note:
This appliance must be electrically wired and
grounded in accordance with local codes or, in the absence
of local codes, with
National Electric Code ANSI/NFPA
70-latest edition
or the
Canadian Electric Code,
CSA C22.1.
A. Recommendation for Wire
Shock Risk
Explosion Risk
Do NOT wire 110V to valve.
Do NOT wire 110V to wall switch
• Incorrect wiring will damage millivolt
values.
• Incorrect wiring will override IPI safety
lockout and may cause explosion.
WARNING
• This appliance may be used with a wall switch.
•
Use low resistance thermostat wire for wiring from ignition
system to the wall switch.
• Keep wire lengths short as possible by removing any
excess wire length, not to exceed 18 ft.
•
Low voltage and 110 VAC voltage cannot be shared within
the same wall box.
C. Intellifi re Ignition System Wiring
•
This appliance requires two “D” size batteries (3V) supply
to the appliance valve for operation. A wiring diagram is
shown in Figure 7.1.
• This appliance is equipped with an Intellifi re control valve
which operates on a 3 volt system.
• This appliance is supplied with a battery pack which is
located inth e ON/OFF switch terminal box.
• The battery pack requires two D cell batteries (not
included).
7
Electrical Information
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
CAUTION
Shock Risk
•
Replace damaged wire with type 105° C
rated wire.
• Wire must have high temperature
insulation.
CAUTION
B. Connecting to the Appliance
IGNITION MODULE
3 VAC
GRN
ORG
INTERMITTENT
PILOT
IGNITOR
IGNITION
MODULE
(3V)
ON/OFF
WALL
SWITCH
LOW VOLTAGE
BATTERY
PACK
FLAME SPARKER/
SENSOR
SEE NOTE 1
ORG
WHT
PIGGYBACK
ON/OFF SWITCH
BRN
BRN
VALVE
VALVE
GROUND TO
FIREPLACE
CHASSIS
I
S
BLACK
RED
BATTERY
PACK
Figure 7.1
Intellefi re Pilot Ignition (IPI) Wiring Diagram
