6
Control Buttons Operation
BUTTON
FUNCTION
ACTION & INDICATION
POWER
ON
: Enables control panel functions and
remote control. Turns on flame effect.
OFF
: Disables control panel functions and
remote control. Turns off flame effect.
1.
Press once
. LED Indicator light turns on.
Power turns on. All functions enabled.
2.
Press again
. Flame effect turns off.
Power and all functions turn off.
HEATER
HEATER button
: Turns heater on and off.
NOTE:
The heater only works when the
flame effect is on. If the flame effect is off,
the heater will not turn on.
NOTE:
To prevent overheating, the heater
blows cool air for 30 seconds before the
heater turns on, and after it turns off.
1.
Press once
. LED Indicator lights up.
Continue press Fan blows cool air for 30
seconds.then Low heater turns on and
blows warm air.
2.
Press again
. LED Indicator lights up.
High heater turns on and blows hot air.
3.
Press again.
Heaters turn off.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2.
Turn the ON/OFF switch on the CONTROL PANEL to OFF.
Wait 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional.
FLAME +
FLAME “+”
: Makes flame effect brighter.
NOTE:
Flame effect stays on until power
button is turned off. Flame effect must be
on for heater to turn on.
2. 1.
Press once
. LED Indicator light turns
on, Flame effect brighter get ready to
adjust.
2.
Press again until desired setting is
reached
. Flame effect continues to get
brighter each time button is pressed.
HEATER
HEATER button
: Turns heater on and off.
NOTE:
The heater only works when the
flame effect is on. If the flame effect is off,
the heater will not turn on.
NOTE:
To prevent overheating, the heater
blows cool air for 30 seconds before the
heater turns on, and after it turns off.
1.
Press once
. LED Indicator lights up.
Continue press Fan blows cool air for 30
seconds. Then Low heater turns on and
blows warm air.
2.
Press again
. LED Indicator lights up.
High heater turns on and blows hot air.
3.
Press again.
Heaters turn off.
The fan blows cool air, then turns off.
NOTICE
To improve operation,
aim
the remote control at the front of the fireplace.
DO NOT
press the buttons too quickly
. Give the unit time to respond to each command.
