30
Use & Care Guide
Replacing Light Bulbs
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before replacing light bulb. After
replacing light bulb, reconnect power.
To avoid personal injury or property damage,
observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
Fresh Food Section
(style of light shield varies)
1. Slide clear light
shield toward back of
compartment to release
from light assembly.
2. Remove light bulbs.
3. R e p l a c e w i t h
appliance bulbs
no
greater than 40 watts
.
4. Replace light bulb cover by inserting tabs on
light shield into liner holes on each side of light
assembly. Slide shield toward front of refrigerator
until it locks into place. Do not force shield
beyond locking point. Doing so may damage
light shield.
Freezer
(style of light shield varies)
1. Reach behind the
light cover.
2. With firm pressure,
press forward on the
notches at the back of
the cover and pull down
the cover will open from
the back.
3. Remove the cover.
4. Remove light bulb.
Energy Saving Tips
• Avoid overcrowding refrigerator shelves. This
reduces air circulation around food and causes
refrigerator to run longer.
• Avoid adding too much warm food to refrigerator
at one time. This overloads compartments and
slows rate of cooling.
• Do not use aluminium foil, wax paper, or paper
towelling as shelf liners. This decreases air flow
and causes refrigerator to run less efficiently.
• A freezer that is two-thirds full runs most
efficiently.
• Locate refrigerator in coolest part of room. Avoid
areas of direct sunlight, or near heating ducts,
registers or other heat producing appliances. If
this is not possible, isolate exterior by using a
section of cabinet.
• Clean door gaskets every three months
according to cleaning instructions. This will
assure that door seals properly and refrigerator
runs efficiently.
• Take time to organize items in refrigerator to
reduce time that door is open.
• Be sure your doors are closing securely by
levelling refrigerator as instructed in your
installation instructions.
• Clean condenser coils as indicated in the
cleaning instructions every three months. This
will increase energy efficiency and cooling
performance.
WARNING
CAUTION