3
Assembly of Range Body to Base
Lift the range at the front and rear,
do not lift by nickel trim.
1.
The range body rests directly on the base - no bolts are required. Two people are needed to lift it on
to the base.
2.
In order not to damage the nickel trim or enamel finish, lift the range from the front and the rear . The
person at the front can first remove the oven door and use the oven opening for a hand hold. The rear
of the oven body at the bottom can be used to lift from the back.
3.
Lift the range off pallet and onto base, making sure the range is sitting square and level on base. The
stove sits over the lip of the base assembly. Helpful hint: Instead of trying to square the entire stove
over the base, put one side or back on first then slowly lower the other side into position.
4. Lastly, install the oven vent deflector on the top of the cooking surface over the oven vent. Loosen
the two screws enough to slip the oven vent under the screws , and tighten up the screws. (see
illustration below)
Loosen two screws
Oven vent deflector
Oven vent
