10
Hearthstone Quality Home Heating Products, Inc. ®
Assembly: Zenith Fire Pit Grill
Carefully remove all components from the shipping
materials. Place the Zenith base in the center of your
chosen install location. Adjust the four leveling feet
until the base level and stable (does not wobble).
Adjust the domed carriage bolts on the top of the
base so that they are approximately the same height.
These can be adjusted to prevent the Fire Bowl
Assembly from wobbling in place.
With help from another person, place the Fire Bowl
Assembly onto the leveling base, and make effort to
center it visually. Place the Plug (item 2101-060) into
the center hole and align the raised bosses on the
plug with the overlapping seam of the two bowl
halves. Next, place each Fire Grate (items 2101-
050) into the Fire Bowl with the raised bosses of the
Ash Grates facing down. The grates should lock in
with raised bosses of the Fire Bowl seam, and Plug.
Assembly: Cooking Ring
Carefully remove all grills, griddles, and hardware
from their packaging. If you have a combination of
grills and griddles, decide in which configuration
you’d like the slotted grills and flat griddles arranged.
Place the grills and griddles face down and spaced
apart on a clean, flat surface in the desired
configuration. One by one, bring the pieces together
and loosely secure each grill or griddle to the
adjacent piece using the supplied hardware: 2x Bolt
(item 4500-3125) and 2x Washer (item 4600-0805).
The completed ring will need 8x each Bolt and
Washer once fully assembled.
When each segment of the grilling ring is loosely
assembled as desired, check the general alignment
for roundness making any adjustments needed, and
then be sure to securely tighten each fastener. With
help from another person, lift the cooking ring, turn
right side up, and place centered over your newly
installed Fire Pit. Center the ring and rotate it to the
desired orientation.
Assembly: Cosmo Fire Pit Grill
Carefully remove all components from the shipping
materials. Install the 4x CAP SCREWS (item 4500-
2495) into the underside of the Meteor Base (item
2101-110). Turn the assembled Base over and
place it in the center of your chosen install location.
Adjust all four screws until the Base is level and
stable (does not wobble). With help from another
person, place the Fire Bowl (2101-120) onto the
leveling base, and make effort to center it visually.
Place the Fire Grate (item 2101-150) into the Fire
Bowl. The spiral ribs should be pointing down with
the small tabs dropping into the hole in the center of
the fire bowl.
