2
that are attached to the wall switch by plugging in
the male to female connectors. (Connectors are pro-
vided and must be attached to the wall switch wires).
See Figure 2.
3. Turn the ON/OFF rocker switch to the "OFF" posi-
tion.
4. Attach the pigtail wires to the ends of the wires from
the wall switch by plugging in the male to female
connectors.
5. Turn the unit's ON/OFF rocker switch to the "OFF"
position.
2.0 INSTALLATION INSTRUCTIONS
FOR MODELS: CFL-18-NG,
CFL-18-LP, CFL-24-NG, CFL-24-LP,
CFL-30-NG, CFL-30-LP, ST-CFL
2.1 INSTALLING THE WALL SWITCH
1. Install the wall switch in a convenient location and
run low voltage, 2-connector wire from the wall switch
into the fireplace in which the gas log set is installed.
2. Find the male to female connectors provided and
attach them to the ends of the wires that lead to the
wall switch.
3. Find the red and brown pigtail wires labeled "FOR
USE WITH REMOTE OR WALL SWITCH ONLY"
which are attached to the unit's ON/OFF rocker
switch. Do NOT disconnect the existing wires at-
tached to this ON/OFF switch. See Figure 3.
Figure 2
3.0 RECOMMENDED OPERATING
PROCEDURES
1. Follow the lighting instructions section in the fire-
place instruction manual. Be certain that the pilot
light is on and the gas control valve is in the "ON"
position. Be sure that the ON/OFF rocker switch is
in the "OFF" position.
2. Turn the wall switch "ON" to light the burner.
4.0 REPLACEMENT PARTS AND
CUSTOMER SERVICE
Replacement parts and service may be obtained through
your dealer.
Figure 3
WALL
SWITCH
PIGTAIL
WIRES
ROCKER
SWITCH
BLACK
SWITCH
BLACK
WIRE
ROCKER
SWITCH
PIGTAIL
WIRES
DOUBLE
CONNECTORS
