1
Hearth & Home Technologies • IFT-ACM Installation Instructions • 2326-988 • 9/16
Leave this manual with party responsible for use
and operation.
IFT-ACM
IntelliFire™ Touch Auxiliary Control Module
Installation Instructions
1. Introduction
The IntelliFire
™
Touch auxiliary control module (IFT-
ACM) is an AC powered device that controls peripheral
devices such as lights, fans and Power Vents approved
for use in Hearth & Home Technologies products that are
equipped with Intellifire
™
Touch technology. It is con-
nected to and controlled by the Intellifire
™
Touch Elec-
tronic Control Module (IFT-ECM).
2. IFT-ACM Installation
A. Precautions
This device is tested and safe when installed in accor-
dance with this installation manual. Do not install any
components that may be damaged.
Do not modify, disassemble, or substitute any of the com-
ponents included with this kit. Installation of this unit must
be done by a qualified service technician.
The location of this device may affect performance. An
assessment of the location should be done prior to instal-
lation for optimum performance.
Hearth & Home Technologies disclaims any responsibility
for, and the warranty will be voided by, the following actions:
• Installation and use of any damaged system component.
• Modification of the system component.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fire hazard.
• Read, understand and follow these instructions for safe
installation and operation.
B. Determine Location
The IFT-ACM latches to the IntelliFire
™
Touch elec-
tronic control module (IFT-ECM). Remove any material
or objects in the immediate vicinity of the vents on the
IFT-ACM. These vents allow the IFT-ACM to dissipate
excess heat into the air.
The IFT-ACM is approved for interior installation only
and should not be used in exterior installations.
Any additional peripheral devices such as lights, fan
and/or Power Vent must be installed as shown in the ap-
pliance manual.
C. Kit Contents
• IntelliFire
™
Touch Auxiliary Control Module (IFT-ACM)
• Power cable that connects AC receptacle to IFT-ACM
• 1 inch sq. Piece of Velcro
D. Installation Steps
CAUTION! Do not install damaged components. If you
received components that are damaged, contact your
dealer for assistance.
1. Remove the contents from the packaging.
2. Locate the IFT-ECM in the control cavity of the appli-
ance and move the three-position switch to the OFF
position. See Figure 1.
3. Remove protective rubber cap from connector on the
top of the IFT-ECM. See Figure 1.
Figure 1. IFT-ECM
f i r e - p a r t s . c o m
