5
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Lanai 48 See Thru Installation Manual • 4113-901 Rev. D • 8/21
2
Getting Started
A. Design and Installation Considerations
The Lanai series gas appliance is designed for outdoor
use and may be installed as a stand alone unit or built
into a wall.
Outdoor spaces - For the purpose of these instructions,
an appliance is considered to be outdoors if installed
with shelter no more inclusive than:
1.
With walls on all sides, but no overhead cover
2. Within a partial enclosure which includes an
overhead cover and no more than two side
walls. These side walls may be parallel, as in a
breezeway, or at right angles to each other; or
3. Within a partial enclosure which includes an
overhead cover and three sidewalls, as long as
30 % or more of the horizontal periphery of the
enclosure is permanently open. See Addendum
on page 24.
NOTE: Screen may be used on the open sides of the
shelter. 14x18 and 16x18 screen mesh is approved for
use. DO NOT use solar screen or no-see-um screen.
The appliance may be installed on a wood or non-
combustible deck.
Refer to section three for clearances.
Installation MUST comply with local, regional, state and
national codes and regulations. Consult the authorities
having jurisdiction over restrictions, installation
inspection and permits.
Before installing, determine the following:
•
Where the appliance is to be installed.
– Clearances to side walls.
– Location of indoor appliance terminations, air
inlets, gas meters, etc.
– Location of the appliance to a door that swings
open to ensure it doesn’t interfere with the
appliance when opened
– Location of Windows.
– Location of Walkways.
– Possibility of flooding or running water.
• Gas supply piping requirements.
• Electrical wiring requirements.
•
Framing and finishing details.
B. Tools and Supplies Needed
Before beginning the installation be sure that the
following tools and building supplies are available.
Tape Measure
Framing material
Pliers Hammer
Phillips screwdriver
Manometer
Gloves
Framing square
Voltmeter
Electric drill and bits (1/4 inch)
Plumb line
Safety glasses
Level
Reciprocating saw
3/4 inch wrench
Crescent wrench
7/8 inch wrench
1/4 inch nut driver
7/16 inch wrench
pipe sealant
Flat head screwdriver
Non-corrosive leak check solution
1/2 - 3/4 inch length, #6 or #8 Self-drilling screws
Caulking material (300°F Minimum continuous
exposure rating.)
Installation and service of this
appliance should be performed
by qualified personnel. Hearth &
Home Technologies recommends
HHT Factory Trained or NFI
certified professionals
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualified
service technician, service agency or your dealer.
NOTE:
Installation and repair should be done by a qualified
service person. The appliance should be inspected before
use and at least annually by a qualified service person.
More frequent cleaning may be required as necessary. It
is imperative that the control compartment, burners, and
circulating air passageways of the appliance are kept clean.
