22
1-90-09730R29_02/14
Opening:
The view door must be opened for cleaning of the glass and
scraping of the burn pot. This should be done with the unit off
and cool, in most cases. Although the glass can be cleaned
and burn pot scraped while the unit is at low burn.
1. Lift the door latch forward and up.
NOTE: door latch may
be hot.
Fig. 32
2. Swing the door open to the left, stopping the swing when
resistance is felt. Forcing the door open further than it is
designed, may cause damage to the door or it's hinges.
Top Glass Clip
Side Glass Clip
Nuts
Btm Glass Clip
Side Glass
Window Gasket
Door Assembly
Fig. 34
Fig. 32
Receiving Bolt
WARNING
Door latch
may be hot!
maintenance - Cleaning glass on view door
If the door is going to be opened for an extended period
of time, it is suggested that it be removed. See "Removing
View Door" section below.
3. Inspect the door gasket and glass gaskets for worn or
missing pieces. Replace if necessary. (Fig. 34)
Closing:
When closing the door, always hold the door latch all the way
up until it has caught the receiving bolt. Then push the latch
downward and back until the door is fully seated.
removing view door:
To remove the view door from the stove, hold the door by
the bottom and lift upward, off of the hinge pins. See Fig. 33
The glass in your Harman® stove is a special ceramic glass.
dO NOT
abuse the glass by striking or slamming shut.
Never
burn the appliance if the door glass is cracked or
broken.
replace only
with Harman® supplied 5mm ceramic glass.
wArNINg
- Do NOT Use Substitute Materials.
Clean the glass with a soft cloth and mild glass cleaner. Do
not clean the glass when hot, and avoid the use of abrasive
cleaners.
glass replacement:
Carefully remove all remaining glass and gasket materials
prior to replacing the glass.
Lay the door face down on a flat surface. Remove the glass
retainers and screws. Apply the gasket material to the face
of the new glass. Lay the glass into the door. Lay the glass
retainers into position and install the nuts. Tighten each nut
evenly, to avoid making any stress points.
Fig. 33
CAUTION
!
Do not put excessive downward pressure on the hinge
side of the door while in the open position.
Summary of Contents for Harman
Page 2: ......
