Hearth & Home Technologies • GFK4B Fan Kit • 4016-095 Rev N • 04/21
1
tm
Model:
GFK4B Fan Kit
Installation
Instructions
This fan kit has been tested for use with specific Hearth & Home Technologies fireplaces. Check with your local building
code agency before you begin installation to ensure compliance with local codes, including the need for permits and follow-
up inspections. If you encounter any problems regarding code approvals, or if you need clarification of any of the instruc-
tions contained here, contact your Hearth & Home Technologies dealer. For the dealer nearest you, please visit www.
hearthnhome.com.
The GFK4B Fan Kit has been designed to circulate room air through the appliance to enhance heat output. The fan kit oper-
ates on 120VAC, 60 Hz power. This is available through a receptacle in the factory installed junction box. The junction box
is located in the controls compartment of the appliance.
A control module is provided with the fan kit which automatically turns the fan on and off at preset times and is equipped with
a variable speed control to provide a quiet forced air flow at the desired speeds.
Check Contents of Shipping Carton
Compare contents of carton in Table 1 with the actual parts received. If any parts are missing or damaged, contact your
dealer before starting installation. Do not install a damaged fan kit.
Installation Precautions
The GFK4B Fan Kit is tested and safe when installed in accordance with this installation manual. It is your responsibility to
read all instructions before starting installation and to follow these instructions carefully during installation to assure maxi-
mum benefit from, and safe operation of, the fan.
Note:
An arrow (
) found in the text signifies change in
content.
Sharp Edges
• Wear protective gloves and safety
glasses during installation.
CAUTION
Note:
This appliance must be electrically wired and grounded
in accordance with local codes or, in the absence of local
codes, with
National Electric Code ANSI/NFPA 70-latest
edition
or the
Canadian Electric Code CSA C22.1.
Shock Risk
Explosion Risk
Do NOT wire 110-120 VAC to gas control
valve.
Do NOT wire 110120 VAC to wall switch
• Incorrect wiring will damage millivolt
values.
• Incorrect wiring will override IPI safety
lockout and may cause explosion.
WARNING
Shock Risk
Fire Risk
Use ONLY optional accessories approved
for this appliance.
• Using non-listed accessories voids
warranty.
• Using non-listed accessories may result
in a safety hazard.
• Only Hearth & Home Technologies
approved accessories may be used
safely.
WARNING
Note:
You may not need all parts included with this kit.
Table 1
Contents of Carton
Description
Part
Number
Qty.
Fan
19263A
1
Fan Bracket
4016-099
1
Electrical Cord
26648
1
Control Module
4021-708
1
Air Deflector
22520
1
Fastener Pack
4025-019
1
Magnetic Tape
4021-654
2
Screws
6
Foam Tape
4021-655
2
Wire Assembly
2005-863
1
Jumper Wire
(blue)
1
