HealthWay SuperV 3400, Manual

Page: 10 / 24

10
Healthway © 06/2019 All rights reserved.
Inlet Air Flow
Outlet Air Flow
Fig. 2-1 Fig. 2-2
Installation Procedures
SUPERV 3400 FURNACE INSTALLATION
Determine the correct air flow direction. The inlet air
is marked with an air flow label, the filter header and
high-energy grid should be placed on the inlet side
(Fig. 2-1 & 2-2)
a. If the furnace has a left-side opening, place the air
cleaner unit (default filter direction) on the left side of
the furnace
b. If the furnace has a right-side opening, pull off the
filter access door, flip the unit up-side down, put the
door back, and then place the unit on the right side of
the furnace
Pull up the snap latch, pull out the filter access door,
turn the quarter-turn counter-clockwise to unlock the
filter and slide the main filter out (Fig. 2-3 & 2-4)
Locate the mounting holes from the unit and connect
the unit to the furnace opening (Fig. 2-5). If the furnace
and air cleaner openings are different, use a transition
plenum (Fig. 2-6).
The opening on the Super V System is 21” ×22”.
Mount return ductwork to the air cleaner system (Fig. 2-7)
Slide the main filter into the housing from the front (Fig. 2-8)
Turn the quarter-turn clockwise to lock the filter (Fig. 2-4)
Seat the Filter access door on the bottom snap latch, pull
up the top snap latch and push close the door towards
the housing. (Fig. 2-8)
All electrical connections must be done by a certified
electrician, following the directions listed in this manual.
Check the serial number label for all the electrical requirements for this unit.
Before installation of unit, please remove all dirty filters on return side of the AHU/Furnace.
Do not connect power to the unit until the High Energy Grid wires have been
checked for proper connection.
Fig. 2-5
Fig. 2-7
Fig. 2-6
Fig. 2-8
Fig. 2-3 Fig. 2-4