Healthrider C535e Elliptical, User Manual

Page: 7 / 24

7
5. Tip: Be careful to avoid pinching the wire harness-
es during this step.
While another person holds the Console (5) near the
Upright (2), connect the wire harness on the Console
to the Upper Wire Harness (86). Insert the excess
wire harness into the Upright. Next, attach the
Console to the Upright with four M4 x 16mm Screws
(66).
5
86
66
2
Wire
Harness
5
6. Identify the Left Handlebar (9), which is marked with an
“L” sticker. Insert the Left Handlebar into one of the
Handlebar Legs (79);
make sure that the Handlebar
Leg is turned so the hexagonal holes are oriented as
indicated
. Attach the Left Handlebar to the Handlebar
Leg with two M8 x 45mm Button Bolts (50) and two M8
Nylon Locknuts (46).
Make sure that the Nylon
Locknuts are set inside the hexagonal holes. Do not
tighten the Button Bolts yet.
Apply a generous amount of the included grease to the
Pivot Axle (97) and to two M8 Large Washers (53). Next,
insert the Pivot Axle into the Upright (2) and center it.
Apply more grease to both ends of the Pivot Axle.
Slide a Handlebar Spacer (25) onto the short tube on the
Left Handlebar (9), and rotate the Handlebar Spacer so
the small arrow is pointing toward the floor. Next, slide the
Left Handlebar onto the left end of the Pivot Axle (97).
Finger tighten an M8 x 25mm Patch Screw (22) with an
M8 Large Washer (53) and a Wave Washer (95) into the
end of the Pivot Axle. Then, attach a Handlebar Cap (23)
by pressing its small tabs into the Handlebar Spacer.
Assemble the Right Handlebar (not shown) and the
other Handlebar Leg (not shown) in the same way.
Now, tighten both M8 x 25mm Patch Screws (22) at
the same time.
Grease
Grease
Tube
Arrow
6
97
25
9
2
23
22
53
50
46
Hexagonal
Holes
79
95
4. The Console (5) requires four 1.5V “D” batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the elliptical exerciser has been
exposed to cold temperatures, allow it to warm to
room temperature before inserting batteries into
the Console. If you do not do this, the console dis-
plays or other electronic components may become
damaged.
Remove the battery cover from the Console.
Next, insert four batteries into the battery compart-
ments.
Make sure that the batteries are oriented as
shown by the diagrams inside the battery compart-
ments.
Then, replace the battery cover.
4
5
Batteries
Battery
Cover