3
598-1145-00
DRAFT COPY
Channel DIM:
Dims all light fixtures that are equipped with the dimming feature
that are configured to work with a particular channel. To perform this function,
press the DIM button located by the channel number desired (between 1 and 8).
Pressing DIM repeatedly will toggle thru the different dim levels if the light fixture
is capable of more than one level of dim. Each time the DIM button is pressed,
the channel LED will momentarily light.
The receiver saves the last dim setting used. To recall the last dim setting, press
the DIM channel once.
Note: The receiver must be capable of dimming for the DIM button to work
properly.
Specifications
Range .......................................................................... Up to 100 feet (30.5 m)
Rated Voltage (2-AAA Batteries) .......................................................... 3 VDC
POSSIBLE CAUSE
1. Batteries installed incor-
rectly.
2. Batteries are dead.
1. Dip switch settings on re-
ceiver do not match con-
troller.
2. Wrong group or channel is
selected.
3. Signals from controller are
being blocked, or transmit-
ter is out of range.
4. Batteries are weak.
Troubleshooting Guide
SYMPTOM
Remote con-
trol does not
come on.
Remote con-
trol will not op-
erate receiver.
Technical Service
(Do Not Send Products)
If you experience a problem, follow this guide. You may also want to visit our Web
site at: www.desatech.com. If the problem persists, call* for assistance at 1-800-
858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to:
DESA Specialty Products™
P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service Specialty Products
* If contacting Technical Service, please have the following information avail-
able: Model Number, Date of Purchase, and Place of Purchase.
No Service Parts Available for this Product
SOLUTION
1. Install batteries according
to polarity markings inside
remote control.
2. Replace batteries.
1. Check dip switch settings
on receiver.
2. Verify correct group and
channel are selected.
3. Check for metal objects that
could block the signal, or
reposition the transmitter.
4. Replace batteries.
