HEALTH RIDER H95T, User Manual

Page: 18 / 36

18
HOW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to
cold temperatures, allow it to warm to room tem -
perature before you turn on the power. If you do
not do this, you may damage the console displays
or other electrical components.
Plug in the power cord
(see page 16). Next, locate
the power switch on the
treadmill frame near the
power cord. Make sure that
the switch is in the reset
position.
Next, stand on the
foot rails of the
treadmill. Find the clip
attached to the key
and slide the clip onto
the waistband of your
clothes. Then, insert
the key into the con-
sole. After a moment,
the displays will light.
IMPORTANT: In an
emergency, the key can be pulled from the con -
sole, causing the walking belt to slow to a stop.
Test the clip by carefully taking a few steps back -
ward; if the key is not pulled from the console,
adjust the position of the clip.
IMPORTANT: Before you use the treadmill, take
the following steps to ensure that the the console
shows the correct incline level of the treadmill:
First, press the incline increase button once. Next,
press either the incline decrease button or the low -
est Quick Incline button to set the treadmill to its
lowest setting. When the frame stops moving, the
treadmill is ready for use.
HOW TO USE THE MANUAL MODE
1. Insert the key into the console.
See HOW TO TURN ON THE POWER at the left.
2. Select the manual mode.
When the key is inserted, the manual mode will be
selected. If you have selected a workout, press the
Manual button on the console.
3. Start the walking belt.
To start the walking belt, press the Start button, the
Speed increase button, or one of the Quick Speed
buttons numbered 2 through 18.
If you press the Start button or the Speed increase
button, the walking belt will begin to move at 2
Km/H. As you exercise, change the speed of the
walking belt as desired by pressing the Speed in-
crease and decrease buttons. Each time you press
one of the buttons, the speed setting will change by
0.1 Km/H; if you hold down the button, the speed
setting will change more quickly. Note: After you
press the button, it may take a moment for the
walking belt to reach the selected speed setting.
If you press one of the numbered Quick Speed but-
tons, the walking belt will gradually change speed
until it reaches the selected speed setting.
To stop the walking belt, press the Stop button.
The time will begin to flash in the display. To re -
start the walking belt, press the Start button or the
Speed increase button.
4. Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the
Incline increase or decrease button or one of the
numbered Quick Incline buttons. Each time you
press one of the buttons, the treadmill will gradually
adjust to the selected incline setting.
Reset
ETHE79814
Clip
Key