3
Paper Chart Installation
Use the following procedure to install or
replace a chart in the recorder.
1. Press the raised ends located on either
side of the case lid to remove the lid.
2. Replace the pen cap on pen from the
pen cap holder below the recording
chart. Remove the recorded chart if
present.
3. Place a new chart on the chart hub,
making sure that the center strip is
intact.
4. Set the time by inserting a coin into
the chart hub (pen screw) and turning
clockwise to the correct time (and day
for 7-day units) relative to the time
index clip located at the middle right
hand side of the recorder.
5. Remove pen cap from pen and put it
on pen cap holder below the recording
chart.
6. Replace the lid. At the end of one cycle
(24 hours or 7 days, depending on your
recorder), simply repeat steps 1-6,
replacing the used chart with a new
one.
Pen Installation
Disposable fiber-tipped pens are installed
in this recorder. The pens have a self-
contained ink supply and are housed in
a replaceable cartridge. Normally, a new
cartridge pen will give many months of
recording, depending on usage. When
replacement becomes necessary, use the
following procedure.
1. Carefully lift the pen arm.
2. While holding the pen arm, use your
thumb and forefinger to grasp the pen
cartridge by the finger grips near the tip
of the pen.
3. Gently slide pen cartridge straight off
pen arm.
4. With the pen tip facing the chart, thread
a new pen cartridge onto the pen arm.
Slide the pen cartridge back until you
feel the notch in the pen arm seat
securely around the plastic cartridge of
the pen tip.
5. Lower the pen on the chart.
6. If the pen arm is bent in the process,
carefully bend the arm back so the pen
contacts the paper.
7. Remove the pen cap and store on the
pen cap holder on the lower part of the
unit.
Quick Start
1. These recorders come with 1 AA
battery installed.
2. Set switch on back of unit to the
appropriate motorspeed: 7 day or 24
hour.
3. Replace chart paper, with a new chart.
4. Set the time by inserting a coin into
the chart hub and turning clockwise
until the correct hour is referenced by
the time indicator. (Time indicator is
directly to the right and below the pen
tip.)
5. Remove protective pen cap.
6. The chart movement is self-starting
and runs continuously. Allow unit
to stabilize in environment for 15
minutes.
3
© Health Care Logistics, Inc. 2010
Call Free: 1.800.848.1633 or 1.888 HCL INTL
®
(425 4685)
•
Fax Free: 1.800.447.2923
Website: www.HealthCareLogistics.com • Email: [email protected]
