- 3 –
Reset
If some gears are not indicated correctly, reset the unit and setup it up again.
If you have a SpeedoHealer (or other speedometer calibrator) and you change
the calibration factor, probably you have to reset the GIpro and set it up again.
Cut off the power of the unit 6 times in a row, while the GIpro display is
counting up and shows 3, 4 or 5.
On most bikes, you can power on/off the display by flipping the engine RUN
switch on/off.
Otherwise, you can do this by cycling the ignition key 6 times (have the RUN
switch off).
On the next power up, the display will count backwards (6 to 1).
The memory is clear now and you can perform the Setup procedure.
Troubleshooting
Make sure you connected the GIpro plug to the RED bike connector. There may
be other similar connector which is not red - do not use.
Disconnect the GIpro connector and check whether the pins are broken, bent or
pushed out of position. Spray some WD40 into the connector. Reconnect the
plug, and make sure that all connections are good and the connector is fully
seated.
If you can not execute the Setup procedure, your battery might be old or weak.
Charge the battery or connect another battery using a jumper cable.
If some gears are not indicated properly when the engine is running and clutch is
released, reset the unit and setup again.
If the problem persists, your clutch might be slipping.
Warranty
The unit is completely sealed and epoxy encapsulated, which gives extreme
protection for the internal parts from shocks, vibrations and water.
To ensure trouble-free operation from the start, all units have been extensively
tested prior to shipment.
Our dealers are offering a 30-day money-back guarantee on HealTech products,
thus you will get your money back if the product does not fulfill your
expectations. (All parts must be returned in original condition for full refund.)
Furthermore the product is covered by our 2-year replacement warranty from
the date of purchase.
Web:
www.gi-pro.net
Email:
