UK Combi-Tiller MK II 30/04-2019
11
Back to the table of contents
It is important that no persons are near to the machine as the tine is returning to
the working position with high speed and might throw with soil and stones.
Replacement of wearing point
Before working with the machine’s wearing points, the machine is to be fastened.
This can be performed by trestles under the main frame.
Dismount M16x65 mm bolt (Pos. 1) by means of 2 pcs. 24 mm spanners.
The
wearing point might fall off, when the bolt is removed –
take care of foot and leg
injuries.
Dismount the wearing point by pushing it forward. This might be difficult due to
entrance of soil, and it might be a good idea to use a hammer.
Mount the new wearing point, item no. 645000044 (Pos. 2), by pushing the wearing point
to the rear and then in its place.
Check the M16 x 65 mm bolt for eventual damages and replace it as required, item no.
690 690113008.
Mount the M16 x 65 mm bolt (Pos. 1), lubricate and tighten it with approx 20 Nm.
Be carefull not to overtighten – the wearing point can be damaged
2
1
