8
9
Revolutionary 2 in 1 design
For use with Staples, L-Cleats.
Non-marring design
Provides increased protection from marring when
working with a finished flooring surface.
Durable construction
Light weight and durably constructed of high-strength
aluminum and heat treated steel parts.
Mallet included
Operation
Prepare the tool
1
The tool is shipped with the arm (A) part detached from the
Main body part.
Loading L cleat nails
2
Connect the tool to the air source.
Press down on the latch button (F). Pull the magazine
cover (D) back to the end of the magazine.
Place full clip of desired fasteners into magazine from the
side. Up to 100 cleat nails can be loaded into magazine.
Be noted that, when loading the L cleat nails, the side
with the L head should be in the left of the magazine
pusher (E).
Push the magazine cover (D) forward until magazine
pusher (E) pops up.
WARNING: If any parts are missing, do not operate this
tool until the missing parts are replaced. Before using
this tool, make sure the arm part and the main body
part are screwed together tightly. Failure to do so
could result in possible serious personal injury.
HOMEDEPOT.COM
Please contact 1-800-514-6729 for further assistance.
Specifications
Features
Follow these instructions to prepare the tool for using.
Set the arm (A) against the Handle .
Wrench-tighten the nuts (B) until the arm (A) and Handle
(C) are secured and the arm (A) is locked against Handle
(C).
Nut (B)
Hex. Bolt
Arm (A)
Handle (C)
Prepared
Flooring Nailer
Magazine
pusher
(E)
Magazine
cover
(D)
Latch button(F)
Loading staples
3
Connect the tool to the air supply.
Press down the latch button (F), the pull the magazine
cover (D) back to the end of the magazine.
Place a full clip of 1/2 in. crown staples in the magazine
from the top. Up to 90 staples can be loaded into
magazine.
Push the magazine cover (D) forward until the magazine
pusher (E) pops up.
Load staples
from the top
Magazine cover
(D)
Latch button (F)
Magazine
pusher
(E)
.
Air inlet: 1/4 inch NPT
Magazine capacity:
L Cleats: 100pcs, Staples: 90pcs
Weight: 8 8 lbs
Maximum pressure: 115 psi
Pressure range: 70 psi
–
115 psi
Pin size range: 1-1/2 inch to 2 inch
Compatible With Generic Brands of 15.5 Gauge Staples & 16
Gauge L-Cleats.
(16Ga. L Cleats)
7.2mm (9/32
”
)
38 mm
45 mm
50 mm
1-1/2
”
1-3/4
”
2
”
(15.5 Ga. Staples)
12.7mm (1/2
”
)
38 mm
45 mm
50 mm
1-1/2
”
1-3/4
”
2
”
L Cleat head
direction
