Page
7
of
27
HDDSURGERY
Lomina 33, 11 000 Belgrade, Serbia
phone +381 11 361 43 43
www.hddsurgery.com
Tools for data recovery experts
4.
Turn the tool upside-down and screw the
bottom cylinder
in the hole on the bottom
side until it hits the drive itself.
5.
Through the bottom cylinder, screw the
spindle-pushing screw
to start pushing out the
bearing from the hard drive case. Since this screw is not long enough to push out the
bearing completely, we must use the
piston
.
6.
Remove the spindle-pushing screw, place the
piston
inside the bottom cylinder, and
then screw the spindle-pushing screw again to push out the bearing completely.
Pushing out the bearing from hard drive casing
After pushing out the bearing, it comes out along with the platter carrier - “the hat”.
7.
Turn the tool upside-down again and remove the hard drive casing.
8.
Position “the hat” with bearing above the bottom hole on the tool the same way like
when placing the hard drive (using the needle).
Pushing out the bearing from “the hat”
