Page
15
of
27
HDDSURGERY
Lomina 33, 11 000 Belgrade, Serbia
phone +381 11 361 43 43
www.hddsurgery.com
Tools for data recovery experts
Using “the puller”
a)
Pull out the
needle
from the bearing by unscrewing the
needle-screw
in the upper
cylinder. Also, remove the bottom cylinder (be sure that the clamping nuts on it don’t
move).
b)
Place
“the puller”
in the bearing casing through the bottom hole on the tool. Push “the
puller” all the way through.
Placing “the puller” in the bearing casing
“The puller” with bearing casing
c)
Screw the
needle-screw
again but slowly by hand. The needle will start pushing
“the
puller”
until it gets to its position and starts gripping the bearing casing.
d)
When “the puller” had gripped the bearing casing, screw the
bottom cylinder
again, and
then screw the
needle-screw
to push out the bearing casing. After this, unscrew the
needle-screw to pull the needle out, and unscrew the bottom cylinder along with
clamping nuts (make sure not to move the clamping nuts).
