Layer Voice - Volume Balance
The parameter sets the balance volume between the 2 layered sounds.
Press the
[Layer]
button, so you are now in Layer mode. Press the Arrow Up
[Select ]
button (to the
left of the screen). This parameter sets the volume between the layered voices. The display scrolls
VOL:0 ( 0 is the default settering). Use the {Prev -] button to decrease the volume of the left hand
(secondary voice). The range will be from 0 to -9. Press the [+Next] button to increase the volume of
the left hand (secondary voice). The range will be from 0 to +9. This will allow you to custom balance
your two desired voices.
NOTE:
Pressing the
[Prev -]
or
[+Next]
button pair together will reset the layer balance back to
factory default of 0. Press and hold any of the “Favorites” buttons 1-6 to save your setting.
Layer Octave Transposition
This parameter sets the transposition of the secondary voice (left hand) relative to the primary voice.
In
LAYER
mode, press the Arrow Up
[Select ]
button, until you arrive at the LED screen display:
XPOSE:0. To transpose the secondary voice up an octave, press the
[+Next]
button once.
(The screen will display 12). Press the
[+Next]
button twice to move up 2 octaves. (The screen will
show 24). Toggle twice back to 0 for the default setting. To lower an octave, simply reverse the steps
by pressing [Prev -] button to change or lower the octaves for the left hand (secondary) voice.
NOTE:
Pressing the
[Prev -]
or
[+Next]
button pair together will reset the octave back to
factory default of 0. Press and hold any of the
[Favorites]
buttons 1-6 to save your setting.
Chapter 6
LAYERING
VOL : 0
XPOSE: 0
26
