HDanywhere MHUB PRO 2.0 (4x4) 40, Product Manual

Page: 13 / 42

OUT IN
B A
13
MHUB PRO 2.0 Display Receiver: front & rear panel
1. Power LED : Indicator light. If this light is on and solid then the display receiver has power.
2. Firmware Update: Micro USB port for firmware updates via PC software.
3. Power : DC24V / 1A. The display receiver is powered via Power over HDBaseT (PoH) from MHUB. The port is there in case of PoH failure.
4. Video : HDBaseT link between MHUB and display receiver. This port has two indicator lights. Left light: solid means connection between MHUB and display receiver is
good. Flashing means that the connection is poor. Off means that there is no connection detected. Right light: solid means HDCP is detected. Flashing means there is no
HDCP. Off means there is no HDMI signal at all.
5. IR IN : Connect an IR RX to send a remote (IR) control command from the display receiver to MHUB’s active “Source IR (OUT)” port.
6. IR OUT : Connect an IR TX to this port to control displays using remote (IR) control commands.
7. HDMI (OUT) : Connect a HDMI cable from the display receiver to your display to provide a picture.
8. RS232 (OUT) : Will output a serial command from MHUB’s RS232 (IN) port to a display. Communication is bi-directional. Wired (B/GND/A).
9. LAN : Connect to any networked device to provide 10/100 LAN access. (MHUBPRO288100 only).
9 8 7 6 5 4 3 2 1