![HBX WAV-0110 Installation Manual Download Page 7](http://html1.mh-extra.com/html/hbx/wav-0110/wav-0110_installation-manual_2112024007.webp)
H B X W A V - 0 1 1 0 O u t d o o r W i r e l e s s S e n s o r
V e r s i o n 1 . 0
© HBX Control Systems Inc. 2015
Page 7
Initial Setup and Pairing
• Once you connect 24 VAC to the base unit, the red
power LED (D2) will start to flash (after a 15 seconds
startup process). (see FIG 3)
Base Unit
FIG 3
• Remove the battery tab from the outdoor unit.
(see FIG 4)
Base Unit
FIG 4
• Hold the outdoor unit within 1 foot of the base
unit during this pairing. (see FIG 5)
Base Unit
FIG 5
Outdoor Unit
OZ
OZ
OZ
THERM OUT
24 VAC GND
C R
Red LED
D2
• Push and hold the button located on the outdoor
sensor until the red LED light turns off (approx. 15
seconds), then release the button. The LED will
switch back on after a few seconds as it is initiating
the pairing process. (see FIG 6)
Outdoor Unit
FIG 6
• Once paired, the outdoor sensor will blink 3 times.
Wireless pairing is successful when you see the green
LED on the base unit flash. The green LED should
flash up to 6 times, indicating good signal strength.
You can then put the front cover on both the base
and the outdoor sensor. At this point, you will install
the outdoor sensor. (see FIG 7)
FIG 7
Red LED
D1
OZ
OZ
OZ
THERM OUT
24 VAC
C R
Green LED
Base Unit
Red LED
Outdoor Unit
OZ
OZ
OZ
THERM OUT
24 VAC
C R
Battery Tab
Max 1ft
OZ
OZ
OZ
THERM OUT
24 VAC
C R
Battery Tab
Max 1ft