19
©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
10 Preparing the Fully Automatic Stud Feeder (VBZ)
10
Preparing the Fully Automatic Stud Feeder (VBZ)
10.1 Adjusting the VBZ
Remove the cover on the separator cage.
Take care not to lose the o-ring
(pos. 20)
, which is located between the cover and
separator cage.
Without the o-ring, feed problems will occur.
Loosen the screw
(pos. 1)
to swivel the feeding bowl
(pos. 10)
.
Loosen the two screws
(pos. 3)
; the separator
(pos. 9)
can then be adjusted in
the vertical direction with the screw
(pos. 2)
.
Loosen the screws
(pos. 4 and 5)
to adjust the angle of inclination to the stud
outlet guide
(pos. 11)
.
If the screws
(pos. 6)
are loosened, the entire unit
(pos. 9)
can be moved horizon-
tally and turned slightly.
Summary of Contents for VBZ-3
Page 39: ......
