HBM TOP-Z30A, Mounting Instructions

Page: 44 / 72

44
TOP-Z30A/Z4A
A2212-1.0 de/en HBM
3 Structure and mode of operation
3.1 TOP-Z30A
Fig. 3.1 TOP-Z30A (100 N...10 kN)
The measuring body consists of a measurement spring system with strain
gages. The internal threads located on both sides are used to apply tensile
forces. Load buttons to screw into the upper thread are available as
accessories to apply the compressive forces.
All nominal forces of the TOP-Z30A have the same size.
The electric connection is implemented with Binder connectors.
To reduce the bending moment during tensile measurements, caused by the
cable in lateral cable outputs, an additional connector is located on the floor of
the housing.
Every TOP-Z30A force transducer comes with TEDS (Transducer electronic
Data sheet); see chapter 6.3.