HBM PX401, Operating Manual

Page: 206 / 552

Internal calculation channels
206
A4354-2.2 HBM: public
PMX
Parameters count mode: positive edge / negative edge / both edges
timeout in ms: Resets the counter when no countable edge
has been detected. Maximum 50 x 10 ms. 0 ms means the
timeout is disabled
A value that controls the flag
Default input: Constant low
enable: Constant high
reset: Constant low
count mode: Positive edge
timeout: 0 ms (= no timeout)
flag control value: 1
Exception handling None. The output is always valid.
13.2.3.5 Integrator
Function Integrates a signal up to the user defined limits.
Inputs In: The signal to be integrated
Reset Flag: Resets the output value to the value at input Init
Value.
This flag is level sensitive. While being high, the Init Value is
output. Init Value: The value at this input is applied with the
Reset Flag.
Outputs Out: The integrator value
Parameters Integration Time [s]:
Defines the time, after which the output equals a constant
input (step function applied at t=0).
Resolution = 1/Calculation Rate, see above.
Y Max, Y Min: The limits of the output.
While limited, the integrator does not wind up in the
background.