HBM ClipX, Operating Manual, Page: 78 / 248

Operation via fieldbus
76
a4643-1.0 HBM: public
ClipX
8.4 Data transfer from the ClipX to the controller
See also Data types used by the ClipX .
The following table sets out the data and the speed at which the data are
updated by the ClipX in the event of a change. The speed (cycle in ms) is not
synchronized with the fieldbus, or with PROFINET IRT or EtherCAT Distributed
Clocks.
Expla-
nation
Format
Cycle in
ms
Explanation
ADC value
REAL 0.052
Output signal of the A/D converter in digits.
Electrical
value (field
value) Input signal in the unit of the measured vari-
able, e.g. in mV/V.
Gross value Gross signal.
Net value Net signal.
Minimum
value Peak value minimum.
Maximum
value Peak value maximum.
Peak-to-peak
value Peak value peak-to-peak.
Captured
value 1
REAL 1
Captured value 1.
Captured
value 2 Captured value 2.
ClipX bus
value 1 … 6
REAL 1
Value on the device's ClipX bus with address
1 … 6.
Calculated
value 1 … 6
REAL 1
Value of calculation channel 1 … 6.
Limit values
1 … 4
REAL
Event-
controlled
Value of the respective limit value 1 … 4.