Scope of supply, accessories and equipment variants
10
A03729_03_YI0_01
HBM: public
C9C
2. Device plug/electrical connection
We can fit one of the following plugs to the C9C on request:
- D-SUB connector, 15-pin: A 15-pin plug for connection to numerous
amplifier systems, e.g. MGCplus, Scout, MP85, etc.
- D-SUB HD connector: A 15-pin plug for connection to appropriate
amplifier systems, e.g. the HBM QuantumX system
- 3106 PEMV connector (Greenline): For connection to appropriate
amplifier systems, e.g. MGCplus with AP03.
- Free ends: Transducer delivered without plugs.
- The force transducer can be ordered with a permanently connected
amplifier electronics module which converts the output signal of the force
transducer into a 0 ... 10 V signal. This option is only available with 1.5 m
and 3 m cable lengths.
- The force transducer can also be ordered with a permanently connected
amplifier electronics module which converts the output signal of the force
transducer into a 4 … 20 mA signal. This option is only available with
1.5 m and 3 m cable lengths.
3. TEDS
You can order the force transducer with transducer identification ("TEDS").
TEDS (Transducer Electronic Data Sheet) allows you to store the trans
ducer data (characteristic values) in a chip that can be read out by a
connected measuring device (with an appropriate amplifier). HBM records
the TEDS data before delivery so that no parameterization of the amplifier
is necessary.
TEDS can only be fitted in the plug of the C9C, therefore it is not possible to
equip the "free cable ends" version with TEDS. The versions with
permanently connected amplifier electronics cannot be connected with the
TEDS option.
