CONTROL
Longitudinal Handwheel
{A, Fig. 04)
Located on two side of the table. Moves table side to
side.
Cross Feed Handwheel
{B, Fig. 04)
Located on the front of the base. Moves table toward,
or away from the column.
Head Elevating handwheel
(C, Fig.05),
Locate on the right of column. The head can be
adjusted up or down to suit height requirements for
different workpieces. Turn it clockwise to up head on
the column and counter-clockwise to down.
When the
head is at the desired height, Iock in place with the
locks.
Caution: Have to loosen the locks for the slideways
before above operation!
Adjustable Table Stops
(D, Fig.06)
Located on table front. Adjust to stop table at any
setting along the longitudinal axis.
Table locks
Longitudinal table locks {E, Fig. 06) are located on
front of the table. Cross-feed table locks (F, Fig.05)
are located on the right side under the table. Turn
clockwise to Iock the slideways.
Mill Head locks
(G, Fig.07)
Located on the right of column. Turn clockwise to Iock
the mill head.
Quill Lock Lever
(H, Fig. 07)
Located on the left of the mill head. The height of the
spindle can be locked with the quill Iock lever. Set the
desired height with the quill lever and turn the lever
down. Turn clockwise to Iock the quill, reverse to
loosen.
Caution: For best results. Ali milling operations
should be done with the quill/spindle as close to the
head assembly as possible. Lock spindle, table and
"
mill head in place before starting milling operations!
- 8 -
Fig. 04
Fig. 05
Fig. 06
Fig. 07
