AD103C
SAFETY INSTRUCTIONS
4
S
Do not allow the equipment to become dirty or damp.
S
During installation and when connecting the cables, take action to prevent electro
static discharge as this may damage the electronics.
S
The required power supply is an extra-low voltage (5V) with safe disconnection from
the mains.
S
Comply with the relevant safety requirements when connecting additional devices.
S
Shielded cables must be used for all connection cables. The whole surface of both
sides of the shield must be connected to earth.
The power supply and digital I/O connection cables only need to be shielded if the cables
are longer than 30 m or are routed outside closed buildings.
S
By way of the CE mark, the manufacturer guarantees that the product complies with
the requirements of the relevant EC directives (the Declaration of Conformity can be
found at
S
In accordance with national and local environmental protection and material recovery
and recycling regulations, old devices that can no longer be used must be disposed of
separately and not with normal household garbage.
If you require more information about disposal, please contact your local authorities or
the dealer from whom you purchased the product.
It is strictly forbidden to carry out any repairs and soldering work on the boards or to
replace any components. Repairs may only be carried out by persons authorized by Hot
tinger Brüel & Kjaer GmbH.
All the factory defaults are stored at the factory, where they are safe from power failure
and cannot be deleted or overwritten, and where they can be reset at any time using the
TDD
0 command. For more information, see the PanelX Help AD103C; Standard com
mands.
The factory-set production number must not be changed.
The transducer connection must always be assigned. The connection of a transducer or
bridge model is essential for operation.
The AD103C is designed for a supply voltage (bridge excitation voltage) of
5
V
DC
.
After the voltage is switched on, the AD103C amplifier needs a warm-up time of 15 min
utes.
