Individual display settings
The transmitter display enables the individual adjustment of the following basic settings:
Display
brightness
Fixed text in line 1
Fixed text in line 2
Note:
Always perform individual settings while the battery is charged. An empty battery can lead to an
automated shut-down during the setting process and to the loss of all entries up to this point.
Access
The mentioned settings are only accessible in a special settings mode. To access this mode, the
transmitter first has to be deactivated via the STOP switch. Afterwards there are 2 possible procedures,
according to the transmitter version.
Standard version (=
without
HBC Smart Card)
Perform the following steps in max. 4 seconds:
1. Press the button on the right side of the
button in the second step and keep it actuated.
2. Pull the STOP switch.
3. Press the
button momentarily and release it. If the
button is actuated for longer than half a
second, the transmitter turns off!
4. Press the
button again until the status LED flashes green.
5. MENU ADJUSTMENT is now shown in the display. Release the
button and the button on the
right side. You are now in the first menu level.
Version
with
HBC Smart Card
Perform the following steps in max. 4 seconds:
1. Press the button on the right side of the
button in the
second step and keep it actuated.
2. Pull the STOP switch. APPLY SMART CARD is now shown in
the display.
3. Hold your HBC Smart Card to the lower end of the transmitter
(cf. illustration).
4. The status LED flashes green. MENU is shown in the first text
line, ADJUSTMENT in the second text line.
Release the button on the right side of the
button. You are
now in the selection menu.
