Operation
The transmitter is equipped with an electronic radiomatic
®
iLOG key.
radiomatic
®
iLOG contains all the data required for operating the transmitter.
Operation is not possible without radiomatic
®
iLOG!
Depending on the version the radiomatic
®
iLOG can also be used for
operation of replacement transmitters of identical construction.
When activating the transmitter and if the radio connection is interrupted (e. g.
if the connection is lost or the transmission range is exceeded), the
transmitter reacts with the so-called enforced zero-position.
Release all operating elements so they can return to the zero-position and
actuate the Start-button. The machine will not react if the operating elements
are not in zero-position. This prevents uncontrolled machine movements after
the radio connection has been interrupted.
Activating the Transmitter
With standard start sequence
Insert a charged battery into the battery compartment.
The following steps need to be carried out within
4 seconds
:
1. Pull the STOP switch. ENTER START-SEQ is now shown in the display.
2. Press the
button for a short time. The
symbol appears in the
display. Release the button. The transmitter will switch off if the button is
pressed for longer than half a second!
3. Press the
button again. The
symbol appears in the display.
Keep the button pressed until the status LED flashes green. Then release
the button.
4. The symbols
and two text lines appear in the display.
The transmitter is now ready for operation.
Note:
The transmitter switches off when
the
button is pressed for longer than half a second in step 2 of the start sequence.
the start sequence is not completed within 4 seconds.
another button is pressed during the start sequence.
In such cases, press the STOP switch and repeat the entire start sequence!
Example
STOP switch
Start button
Status LED
radiomatic
®
iLOG
