HB-THERM T24693, Assembly Instructions Manual

Page: 3 / 8

Assembly Instructions M8100-EN
M8100-EN 2018-03
3/8
Fig. 4: Front side of the evaluation unit
Fig. 5: Rear side of the evaluation unit
6. Proceed as follows in order to attach the cover of the
evaluation unit:

Connect the ribbon cable to the keyboard and attach the cover.

Attach screws (Label 1

Fig. 4).

Tighten screws (Label 2

Fig. 5).
7. Connect control cable to ext. flow rate meter Flow-5.
8. Reconnect mains plug and switch on main switch.
9. Switch the unit on with the key.
NOTICE!
Software version SW51-1_1335 or higher is
required for the printed circuit board DFM-51
(acceptance date 1253 and later). If necessary
perform a software-update (

Thermo-5 operating
instructions)
1
2