17
3
Design and Function
ATTENTION!
Excess oil in the motor will be imme-
diately expelled through the air outlet.
WARNING!
Never point the opening of the outlet
at any person or object. The air outlet
is located behind the handle.
•
Maintenance
Always disconnect the tool from the com-
pressed air supply prior to carrying out
maintenance work.
If used daily, carry out maintenance every
3 months, or every 1000 operating hours at
the latest.
Damaged or worn components such as
O-rings and bearings etc. must be replaced
and all moving parts must be lubricated.
Only use spare parts recommended by the
manufacturer, as any other parts will invali-
date any express or implied warranty.
Ensure that the relevant environmental pro-
tection directives are observed when dispo-
sing of components, lubricants and oils, etc.
For tool cleaning or cleaning of its compon-
ents we recommend using white spirit.
Never clean with solvents or acids, esters
(organic compounds comprising acids
and alcohol), acetone (ketone), chlorinated
hydrocarbons or oils containing nitro hydro-
carbons. Do not use any chemicals with a
low burning point.
For customer service, please contact your
HAZET distributor.
6. Malfunctions
If malfunctions occur, check the following:
• Compression system and compressed air
supply lines,
air consumption l/min and hose
cross section according to the technical
data of the tool
• Check the compressed air for the occurrence
of dust, condensate and rust particles
• Excess lubrication of the air motor
Mini Orbital Sander:
• Push the abrasive paper pad onto the
grinding disc. Check that the abrasive
paper pad is fitted tightly.
• Ensure that you only apply a slight amount
of pressure when using the mini orbital san-
der!
• Replacing the grinding disc:
Release the plastic suction cover and hold
the spindle in place on the hexagon using
the supplied flat wrench. Unscrew the
grinding disc by turning counterclockwise.
Fit the new grinding disc and tighten hand-
tight by turning clockwise.
Polisher:
• Select the tool based on the individual
case of application.
• Check the air pressure and if necessary
adjust to attain the operating pressure.
See table on page 7
.
5. Maintenance and Cleaning
•
Lubrication:
Pneumatic tools have to be lubrica-
ted throughout their entire service life.
The motor and the ball bearings require
compressed air to operate the tool. As
moisture from the compressed air corrodes
the motor, the motor must be lubricated
every day. We recommend an integrated
lubricator is used to do this.
• HAZET 9070-1 Lubricator for mounting to
the pneumatic tool.
•
Lubricating the pneumatic motor by
hand:
Disconnect tool from the air supply and
hold with the air inlet pointing upwards. Put
1 or 2 drops of special pneumatic tool oil
into the air inlet.
Connect the tool to the compressed
air supply; cover the air outlet on the tool
with a towel and operate for a few seconds.
Never use combustible or easily evaporable
liquids such as kerosene, diesel or petrol to
lubricate the tool.
Gehörschutz tragen!
Wear hearing protection!
Summary of Contents for 9033 N-5
Page 19: ...19 Notizen Notes ...