16
3
Design and Function
• Caution is required at all times when using
the grinder/polisher. Negligent operation
may cause damage to the inner parts or the
housing and limit the working performance.
• Press the operating lever to operate the
tool.
• Release the operating lever to stop the tool.
• Please note that the tool still continues to
run after the operating lever has been relea-
sed.
• After completing the operation, switch off
the compressor and store it according to
the operating instructions for the compres-
sor.
• Only use clean and dry air at a max. pres-
sure of 90 PSI or 6.3 bar. Dust, flammable
vapour and high humidity can result in
damage to the pneumatic tool's motor.
• Do not remove any stickers and replace
damaged stickers immediately.
• Keep hands, loose clothing and long hair
away from the tool's moving part.
3. Before starting operation
The pneumatic tools must
always be used, inspected and
maintained in compliance with
the local government, state or
federal regulations.
• Drain the compressor tank and remove the
condensate from the air lines. Carefully read
the operating instructions for the compres-
sor.
IMPORTANT:
We recommend using air fil-
ters and
a compressed air line
lubricator.
ATTENTION!
Disconnect
the
compressed
air supply prior to lubricating,
connecting or disconnecting the
tool.
• Lubricate the tool;
see the section on main
tenance
in these operating instructions.
• Remove the dust cap on the compressed air
inlet.
• Connect the tool to a hose of suitable size.
Table on page 7.
4. Operation
• Switch on the compressor so that the air
tank is filled.
• Turn the compressor regulator to approx.
90 PSI or 6.3 bar. The max. working pressu-
re of this tool is approx. 90 PSI or 6.3 bar.
• The rotational power may vary depending
on the size of the air compressor and the
volume of the compressed air output.
• Do not use defective or worn air hoses or
adapters of inferior quality.
• The pressure for achieving the correct tool
speed is regulated by the compressor regu-
lator or an extra pressure regulator.
• The speed is regulated using an air supply
regulator (not included).
• The technical data given refers to an opera-
tion of the tool at a pressure of 6.3 bar.
Gehörschutz tragen!
Wear hearing protection!
Summary of Contents for 9033 N-5
Page 19: ...19 Notizen Notes ...
