Pool Vac Ultra
MAINTENANCE TIPS
4. FLAP REPLACEMENT:
a) Remove the front and rear flaps from your Pool Vac Ultra by inserting a small screwdriver between
the flap and the lower body near the pivot point of the flaps (see Figure 11).
b) You will notice that your replacement flaps look similar but are marked “Front” and “Rear” on the flap.
Because the springs in the flaps are different, it is absolutely necessary to install the proper flap in
the front and rear of the unit.
Failure to do so will result in unsatisfactory performance of the Pool Vac
Ultra. When installing the front flap, be sure that the extended leg of the spring is inserted into the notch an
the front of the lower body (see Figure 12). Push the flap in place. You will actually feel and hear a snap
when the flap is in place. Fold the flap in towards the bottom of the Pool Vac Ultra. You will feel some
resistance at this point (that is normal). As the flap snaps into its normal position, you will feel the spring
action and notice that the front flap is now in its normal operating position.
When installing the rear flap, the extended leg of the spring must fit against one of the flat surfaces of the cam
(see Figure 12)
.
Figure 11
Figure 12
FRONT
REAR
CAM
BOTTOM OF CLEANER
BOTTOM OF CLEANER
11
