USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
3
Introduction
This manual contains information for the proper installation of the Hayward
®
LGGUY1000 niche. Installation should be performed by a professional.
Failure to install according to the instructions will void the warranty.
Unlike metallic forming shells (niches), the non-metallic design of the LGGUY1000 does not require bonding or grounding and uses PVC over expensive
metal conduit.
This UCL underwater lighting niche is for concrete/gunite pools. When paired with a Hayward Universal ColorLogic
®
or CrystaLogic
TM
LED light fixture,
you have the best quality and value in a lighting system available anywhere. The UCL underwater lighting niche Model LGGUY1000 is furnished with (2)
conduit fittings (reducer and elbow/coupling) to allow for specific installation requirements.
Important Information
1. This UCL underwater lighting niche are Underwriters Laboratories (UL) Listed under Category WBDT. They are C-UL-US Listed for fresh and sea
water and comply with Article 680.23 of the National Electrical Code [NEC].
2. This UCL underwater lighting niche does not contain or require a bonding or a grounding connector. It is designed to exclusively mount the
Hayward all plastic Universal ColorLogic/CrystaLogic LED pool/spa lights. The UL listing for this niche allows it to be used with Hayward’s non-
bonded non-grounded Universal ColorLogic/CrystaLogic low voltage pool/spa lights.
3. This UCL underwater lighting niche model LGGUY1000 is C-UL-US only for use with Hayward Universal ColorLogic/CrystaLogic Submersible Light
Fixture Series LSCUS, LSCUN, LSLUS.
4. All UCL underwater lighting niches must be installed in compliance with Article 680.23 of the National Electrical Code (NEC) and other applicable
electrical codes and with any applicable building codes. Article 680 requires that light fixtures be installed with the top of the lighting lens at least
4 inches ( below the normal water level of the pool or spa.
5. The UCL underwater lighting niches are provided with two (2) Conduit Fittings. A 1”,
45° sweep elbow and a 1”x ¾” reducer bushing are provided for connection conve-
nience to PVC conduit. These conduit fittings must be cemented to the niche, field
supplied conduit pipe and to other conduit fittings using approved PVC primer and
cement.
6. All UCL underwater lighting niches are equipped with an internally-threaded connection
for pressure testing of conduit line before installing light. (a pipe plug must be used.)
WARNING
–
ELECTRIC SHOCK HAZARD. MOUNTING A LUMINAIRE THAT REQUIRES BONDING
OR GROUNDING IN THIS NICHE CAN CAUSE SEVERE INJURY AND/OR DEATH. DO NOT MOUNT NON-UL
LISTED LIGHTS OR ANY LUMINAIRE THAT REQUIRES BONDING OR GROUNDING IN THIS NICHE.
